Technical Bulletin PAGE: 3/5
Reissued: 26-Apr-11
Model: Al-P1 Date: 13-Mar-08 No.: RG179008k
Version Modified Points or Symptom Corrected
3. IPDS jobs are cancelled if submitted to a tray whose paper type is configured as
a "User Paper Type".
4. A form is assigned to a tray (Web Image Monitor > Configuration > Printer >
Basic Settings > IPDS Menu > IPDS Form Allocation), but this form assignment
cannot be seen in the operation panel setting (Menu button > Print Settings >
IPDS menu > Tray Form).
5. The Reset IPDS Fonts confirmation dialogue cannot be closed without stalling
the device.
After the IPDS fonts are reset (Menu button > Maintenance > HD Management
> Reset IPDS Fonts > OK) a confirmation "Are you sure you want to reset IPDS
Fonts?" is shown. This is correct. However, due to this bug, it would be shown
repeatedly if "Yes" was pressed. The only way to close this dialogue was to
press "No". Furthermore, if "No" was pressed after "Yes" had been pressed 3 or
more times, the device would stall.
6. The following steps might stall the device.
- Configure "Menu button > Print Settings > IPDS menu > Color Simulation >
Legacy"
- Navigate to the last page of the IPDS menu and hit the Escape button.
1.16 Symptom corrected:
1. If printing of an IPDS job is interrupted by an error requiring operator attention
(paper jam, cover open, etc.), an alert is sent to the host after the error state has
been recovered, instead of when the device first enters the error state.
2. The device becomes unresponsive displaying "Waiting for Print data..." if any of
the following settings are changed while the device has an active IPDS session.
- Printer Features
- System Settings
- Tray Paper Settings
- Adjustment Settings for Operators
Note: The printer status returned to Ready after the IPDS session timed out.
1.15 Symptom corrected:
1. The use of SDK applications that access the GPS Filter (such as the PDL filter)
might result in slow printing.
2. Printing multiple jobs of differing PDLs to Virtual Printers of differing priorities
might result in the device stalling.
3. If any non-IPDS job in the print queue is deleted while receiving an IPDS job, the
device will stall.
WIM: Job > Current/Waiting Jobs > Delete Reservation
Operation Panel: Job List > Delete Reservation
Other Changes:
IPDS jobs can no longer be deleted from the print queue.
WIM: Job > Current/Waiting Jobs > Delete Reservation
Operation Panel: Job List > Delete Reservation
Note: This change was made because deleting IPDS jobs from the print queue
stalled the device.
To Next Page
Loading...
Need help?
General
