T
echnical
B
ulletin PAGE: 2/2
Reissued: 09-Oct-09
Model:
Al-P1
Date:
23-May-08
No.:
RG179010b
3. Loosen the screw and remove the SD card slot cover at an angle ( x 1).
4. Insert the IPDS SD Card into Slot 1 (Upper slot)
until it clicks.
Important:
- Pushing on the SD Card releases it for removal. Make sure the SD card is inserted
and locked in place. If it is partially out of the slot, push it in gently until it locks in
place.
- If Slot 1 (upper slot) is occupied, insert the attached SD card into Slot 2 (lower slot)
and the IPDS SD card into Slot 1. Then, merge the application into the IPDS SD
card.
5. Reattach the cover and turn ON the main switch.
6.
Do the following setting “A” or “B” to enable the IPDS function.
A. [Enable the IPDS function via telnet]
1. Connect the machine via telnet.
2. Execute the following commands:
msh> set ipds up
***If you want to stop the function.
msh> set ipds down
B. [Enable the IPDS option via WebImageMonitor]
1. Log in to WebImageMonitor.
2. Change the setting to enable IPDS.
To Next Page
Loading...
Need help?
General
