PAGE: 2/14
Installation
Overview
There are several combinations for using "Card Authentication Package" and
"Enhanced Locked Print NX".
Embedded Type A: This is for a customer who wants to use "Card
Authentication Package" and "Enhance Locked Print NX".
Embedded Type B: This is for a customer who wants to use only "Card
Authentication Package".
Server Type A: This is for a customer who wants to use "Card Authentication
Package Enterprise Server" and "Enhance Locked Print NX".
Server Type B: This is for a customer who wants to use only "Card
Authentication Package Enterprise Server".
Here is the matrix of possible combinations.
Embedded
Type A
Embedded
Type B
Server
Type A
Server
Type B
CAP Yes Yes Yes Yes
CAP-ES No No Yes Yes
ELP-NX Yes No Yes No
CAP: Card Authentication Package
CAP-ES: Card Authentication Package Enterprise Server
ELP-NX: Enhanced Locked Print NX (Application and Filter)
Confirmation Points before Installation
Make sure that the firmware of the target machine is the latest version.
Make sure that the firmware of the VM card is the latest version.
Check the following SP settings;
Bit 0 of SP5401-160 (SSP: Super Service Program) must be set to “0”.
All bits of SP5401-162 (Extend Certification Detail) must be set to “0”.
Bit 0 of SP5401-230 (Customized Authentication) must be set to “0”.
To Next Page
Loading...
Need help?
General
