Canceling a Transmission After the Original Is Scanned (While a Transmission
Is in Progress)
Use this procedure to delete a file that is being sent after the original is scanned.
All the scanned data is deleted from memory.
1. Press the [Stop] key.
You can also press [Comm. Status/Print], and then [Check/Stop Transmission File].
2. Press [Standby File List].
3. Select the file you want to cancel.
If the desired file is not shown, press [ ] or [ ] to find it.
4. Press [Cancel TX].
5. Press [OK].
To cancel another file, repeat steps 3 through 5.
6. Press [Exit].
After pressing [Check/Stop Transmission File] under [Comm. Status/Print] in step 1, press [Exit]
twice.
Canceling a Transmission After the Original Is Scanned (Before a Transmission
Is Started)
Use this procedure to delete a file stored in memory before its transmission has started.
Canceling a Transmission
83
To Next Page
Loading...
Need help?
General
