Problem Causes Solutions
Misfeeds occur frequently. Paper of undetectable size
has been loaded.
• Remove misfed paper. For details
about removing jammed paper,
see "Removing Jammed Paper",
Troubleshooting .
• If you load a paper size that is not
selected automatically, you need
to specify the paper size with the
control panel. For details about
specifying paper size with the
control panel, see "Changing to a
Size That Is Not Automatically
Detected", Paper Specifications
and Adding Paper .
Misfeeds occur frequently. There is a foreign object on
the finisher tray.
• Remove misfed paper. For details
about removing jammed paper,
see "Removing Jammed Paper",
Troubleshooting .
• Do not place anything on the
finisher tray.
Misfeeds occur frequently. The staple cartridge is not
set correctly.
Set the staple cartridge properly. For
details about how to add staples, see
"Adding Staples", Maintenance and
Specifications .
Cannot print in duplex
mode.
You have selected a paper
tray that is not set for duplex
printing.
Change the setting for "Apply Duplex"
in [System Settings] to enable duplex
printing for the paper tray. For details
about setting "Apply Duplex", see
"Tray Paper Settings", Connecting the
Machine/ System Settings .
Cannot print in duplex
mode.
You have selected a paper
type that cannot be used for
duplex printing.
In [System Settings], select a paper
type that can be used for duplex
printing. For details about setting
"Paper Type", see "Tray Paper
Settings", Connecting the Machine/
System Settings .
When You Have Problems Operating the Machine
177
To Next Page
Loading...
Need help?
General
