Ricoh Nashuatec CP430 - Page 60

31 October 2001 DRUM
3-25
Replacement
Adjustment
4. Check that the piston motion is smooth.
5. If the motion is stiff, loosen the pump screws [G] and adjust the pump position.
6. After tightening, repeat step 4 and step 3.
7. Re-tighten the two screws [H].
8. Check that the piston motion is smooth.
9. Reinstall the E-ring [C].
C238R016.WMF
C238R017.WMF
[C]
[G]
[H]