16. Press the [ ] or [ ] key to select the security method that is specified for the access point
you want to connect to.
17. Press the selection key beneath [Enter].
Select [WEP] or [WPA2], and then press the selection key beneath [Details] to enter your
password.
If you do not use security setting, select [No].
The settings are complete.
To check the connection status, enter [Wireless LAN Signal] in [Wireless LAN] and confirm the signal
status.
Obtaining an IP address automatically (IPv4 DHCP)
The machine is set to obtain IP addresses automatically as a factory default.
1. Press the [Menu] key.
2. Press the [ ] or [ ] key to select [Host Interface], and then press the [OK] key.
3. Press the [ ] or [ ] key to select [Network], and then press the [OK] key.
4. Press the [ ] or [ ] key to select [Machine IPv4 Address], and then press the [OK]
key.
5. Press the [ ] or [ ] key to select [Auto-Obtain (DHCP)], and then press the [OK] key.
Specifying an IP address (IPv4)
1. Press the [Menu] key.
2. Press the [ ] or [ ] key to select [Host Interface], and then press the [OK] key.
3. Press the [ ] or [ ] key to select [Network], and then press the [OK] key.
4. Press the [ ] or [ ] key to select [Machine IPv4 Address], and then press the [OK]
key.
5. Press the [ ] or [ ] key to select [Specify], and then press the [OK] key.
6. Press the selection key beneath [IP Add.], and then enter the IP address.
7. Press the [OK] key.
1. Getting Started
18
To Next Page
Loading...
