Ricoh P C301W - How to Read This Manual; Introduction and Symbols; Model-Specific Information

7
Easy Setup Using the WPS Button
● Make sure the Ethernet cable is not connected to the
machine.
● In Steps 10 to 12, congure each setting within two
minutes.
● The following item is necessary to set up a wireless
connection.
● Router (access point)
1. Check that the router (access point) is working correctly.
2. Press the [
] or [ ] key to select [Wired (Ethernet)], and
then the [OK] key.
Network Wizard
12
Wired (Ethernet)
DYG081
Wireless (Wi-Fi)
3. Press the [ ] or [ ] key to select [Quit Setup], and then the
[OK] key.
ECB240
Quit Setup
IPv4 Configuration
IPv6 Configuration
44
Network Wizard
4. Press the [Menu] key.
ECB202
5. Press the [ ] or [ ] key to select [Network Settings], and
then press the [OK] key.
ECB206
Print List/Report
Network Settings
Wi-Fi Setup Wizard
86
Settings
6. Press the [ ] or [ ] key to select [Wireless (Wi-Fi)], and
then press the [OK] key.
ECB207
IPv4 Configuration
Wireless (Wi-Fi)
Wired (Ethernet)
51
Network Settings
7. Press the [ ] or [ ] key to select [WPS], and then press the
[OK] key.
ECB215
Current Connection
Input SSID
WPS
96
Wireless (Wi-Fi)
8. Press the [ ] or [ ] key to select [PBC], and then press the
[OK] key.
WPS Type
12
PIN
PBC
DSG092
9. Press the [ ] or [ ] key to select [Yes], and then press the
[OK] key.
ECB216
NoYes
WPS PBC Connect ?
PBC
10. After "Connecting..." appears, press the WPS button on the
router (access point) within two minutes.
WPS
CHV607
• For details about how to use the WPS button, refer to the manuals for
the router (access point).
11. Check the result.
Connection has succeeded:
ECB227
EXIT
has Succeeded
Connection to AP
PBC
• Press the [OK] key to return to the screen displayed in Step 6,
and then press the [Menu] key to return to the initial screen.
Connection has failed:
ECB228
EXIT
has Failed
Connection to AP
PBC
• Press the [OK] key to return to the screen displayed in Step 6.
Check the conguration for the router (access point), then try
the connection again.
12. Configuring the Wi-Fi settings is complete.
To use the printer driver, install the printer driver
according to the procedure on page 10 "3. Installing
the Printer Driver".
Easy Setup Using a PIN Code
● Make sure the Ethernet cable is not connected to the
machine.
● In Steps 11 to 13, congure each setting within two
minutes.
● To establish a connection using the PIN code, use a
computer that is connected to the router (access point).
● The following item is necessary to set up a wireless
connection.
● Router (access point)
1. Check that the router (access point) is working correctly.
2. Open the PIN code configuration window (web page) for the
router (access point) on your computer.
3. Press the [ ] or [ ] key to select [Wired (Ethernet)], and
then the [OK] key.
Network Wizard
12
Wired (Ethernet)
DYG081
Wireless (Wi-Fi)