Message Cause Solution and reference
"Cannot connect with DHCP
server.(101/201)"
An IP address cannot be obtained
from the DHCP server.
Consult your network
administrator.
"Cannot print." The machine cannot print the sent
data.
Check that the file you want to
print is a supported file type.
Check the misfeeds and ask your
network administrator for help.
"Change (Tray name) to the
following settings:"
The size of the paper in the tray
does not match the paper size
specified in the printer driver.
Select a tray containing paper
that is the same size as the
specified paper size.
"Check network settings.
(103/203)"
The IP address setting is incorrect. Check the IP address, subnet
mask, and gateway address.
"Classification Code Error" A classification code is not
specified for the print job.
Enter a classification code using
the printer properties and print the
document again.
"Connect
failed:WirelessCard Turn
power off, check card."
The machine cannot detect the
wireless LAN interface board.
Check that the board is supported
or installed correctly.
"Cover Open. Please close
the indicated cover."
A cover of the machine is open. Close the cover as indicated on
the control panel.
"Duplex mode is in off
position for (tray name)"
The duplex mode for the indicated
tray is not available.
You can use one-sided printing
only. Press [Change] to change
the tray's settings, press [JobReset]
to reset the job, or press [Form
Feed] to force printing.
"Ethernet Board Error" An error on the Ethernet is
detected.
Turn the machine off, and then
turn it on again. If the problem
persists, consult your sales or
service representative.
"Exceeded max. No. of
files."
While printing a Sample Print,
Locked Print, Hold Print, or Stored
Print file, the maximum file
capacity was exceeded.
Delete unneeded files stored in
the machine.
5. Troubleshooting
114
To Next Page
Loading...
