Ricoh PJ X6180N User Manual

28
3. Convenient Features
4 Changing Eco Mode/Checking Energy-Saving Effect Using Eco
Mode [LAMP POWER]
This feature enables you to select two brightness modes of the lamp:
STND. and ECO modes. The lamp life can be extended by turning on the [LAMP POWER].
[LAMP POWER] Description
[STND.] This is the default setting (100% Brightness).
[ECO]
Low lamp power consumption (approx. 80% Brightness).
To turn on the [LAMP POWER], do the following:
1. Press the Eco button on the remote control to display [LAMP POWER] screen.
2. Use the  or  button to select [ECO].
3. Press the Enter button.
To change from [ECO] to [STND.], Go back to Step 2 and select [STND.]. Repeat Step 3.
NOTE:
• The [LAMP POWER] can be changed by using the menu.
Select [SETUP] → [BASIC] → [LAMP POWER].
• The lamp life remaining and lamp hours used can be checked in [USAGE TIME]. Select [INFO.] →[USAGE TIME].
• [LAMP POWER] is always set to [STND.] for 1 minute immediately after the lamp is turned on. The lamp condition will not be
affected even when [LAMP POWER] is changed.
• After a lapse of 1 minute from when the projector displays a blue, black or logo screen, [LAMP POWER] will automatically switch
to [ECO].
• If the projector is overheated in [STND.] mode, there may be a case where the [LAMP POWER] automatically changes to [ECO]
mode to protect the projector. This is called “Forced ECO Mode”. When the projector is in the Forced Eco Mode, the picture
brightness decreases slightly and the Temp. indicator lights orange. At the same time the Thermometer symbol [
] is displayed
at the bottom right of the screen.
When the projector comes back to normal temperature, the Forced Eco Mode is cancelled and the [LAMP POWER] returns to
[STND.] mode.
2. Press the  button.
The area of the magnied image will be moved
3. Press the Magnify (−) button.
Each time the Magnify (−) button is pressed, the image is reduced.
NOTE:
• The image will be enlarged or reduced at the center of the screen.
• Displaying the menu will cancel the current magnification.

Ricoh PJ X6180N Specifications

General

Brightness	6000 lumens
Resolution	XGA (1024 x 768)
Light Source	Lamp
Image Size	30 - 300 inches
Speaker	10W
Display Technology	DLP
Lamp Type	UHP
Native Resolution	XGA (1024 x 768)
Lamp Life	4000 hours (Normal mode), 5000 hours (Eco mode)
Keystone Correction	Vertical ±30°
Input Terminals	HDMI, VGA, USB
Output Terminals	VGA
Control Terminals	RS-232C
Networking	LAN
Power Consumption	350W (Normal mode), 280W (Eco mode)
Input Ports	HDMI, VGA, USB
Output Ports	VGA
Noise Level	37 dB (Normal)