Throughput
CIP Training Pro C5200 series
Low Power mode
If you do not use the machine for a certain period after an operation, the display will
turn off and the machine goes into Low Power mode. The machine uses less electricity in
Low Power mode.
You can change the amount of time that the machine waits before switching to Low
Power mode under [Low Power Mode Timer]. For details, see "System Settings", Device
Management.
You can change the machine's settings to enter Low Power mode when you press the
[Energy Saver] key. For details, see "System Settings", Device Management.
To exit Low Power mode, do one of the following:
• Press the [Check Status] key
Sleep mode
If the machine remains inactive for a specified period or the [Energy Saver] key is
pressed, it enters Sleep mode to further reduce the electricity it consumes. For details,
see "System Settings", Device Management.
When the machine is in Sleep mode, only the [Energy Saver] key and the
[Check Status] key are usable. The machine can print jobs from computers.
You can change the amount of time that the machine waits before switching to
Sleep mode under [Sleep Mode Timer]. For details, see "System Settings", Device
Management.
To exit Sleep mode, do one of the following:
• Press the [Energy Saver] key
• Press the [Check Status] key
• When the machine is in Low Power mode, the [Energy Saver] key is lit. In Sleep
mode, the [Energy Saver] key flashes slowly. In Fusing Unit Off mode, the
[Energy Saver] key is not lit.
• The energy saving functions will not operate in the following cases:
• When fixed warm-up is in progress
• When operations are suspended during printing
• When a warning message appears
(The machine enters Fusing Unit Off mode unless the cover is open.)
• When paper is jammed
(The machine enters Fusing Unit Off mode except when the cover is open.)
• When the Data In indicator is lit or flashing
To Next Page
Loading...
Need help?
General
