Ricoh PRO C7210X

1.SC Codes
176
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Reconnect the connector.
 Replace the Jogger Fence HP Sensor.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC725-
36
B
Direct-Send JG Motor Error
 When moving to the home position, home position was not detected within
specified number of pulses. (The first time: jam display, the second time: SC)
 When moving from the home position, home position was still detected after
specified number of pulses. (The first time: jam display, the second time: SC)
 Motor driver detected an error. (SC from the first time)
 Overcurrent to the motor.
 Motor drive overheat
 Connector disconnected
 Replace the Main Board.
 Replace the Direct-Send JG Motor.
 Replace the harness.
 Reconnect the connector.
 Replace the Direct Send JG HP Sensor.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC725-
37
B
FM6 Pawl Motor Error
 When moving to the home position, home position was not detected within
specified number of pulses. (The first time: jam display, the second time: SC)
 When moving from the home position, home position was still detected after
specified number of pulses. (The first time: jam display, the second time: SC)
 Motor driver detected an error. (SC from the first time)
 Overcurrent to the motor.
 Motor drive overheat
 Connector disconnected
 Replace the Main Board.
 Replace the FM6 Pawl Motor.
 Replace the harness.
 Reconnect the connector.
 Replace the Bypass Exit Paper Sensor.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC725-
B
Fold Plate Motor Error