Ricoh PRO C7210X

1.SC Codes
177
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
38
 When moving to the home position, home position was not detected within
specified number of pulses. (The first time: jam display, the second time: SC)
 When moving from the home position, home position was still detected after
specified number of pulses. (The first time: jam display, the second time: SC)
 Motor driver detected an error. (SC from the first time)
 Overcurrent to the motor.
 Motor drive overheat
 Connector disconnected
 Replace the Main Board.
 Replace the Fold Plate Motor.
 Replace the harness.
 Re-connect the connector.
 Replace the Fold Plate HP Sensor.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC725-39
B
1st Fold Motor Error
 Motor driver detected an error. (SC from the first time)
 Overcurrent to the motor.
 Motor drive overheat
 Replace the Main Board.
 Replace the 1st Fold Motor.
 Replace the harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC725-40
B
2nd Fold Motor Error
 Motor driver detected an error. (SC from the first time)
 Overcurrent to the motor.
 Motor drive overheat
 Replace the Main Board.
 Replace the 2nd Fold Motor
 Replace the harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC725-41
B
Crease Motor Error
 Motor driver detected an error. (SC from the first time)
 Overcurrent to the motor.
 Motor drive overheat