Ricoh PRO C7210X - Page 204

1.SC Codes
200
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Replace the motor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-32
D
Perfect Binder: Signature fan 2 (rear) lock error
See SC750-31
 Rear signature fan 2 overloaded, defective
 Slave Control Board defective
 Reconnect the connector.
 Replace the rear signature fan 2.
 Replace the slave board.
 Replace the motor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-33
D
Perfect Binder: Signature fan 1 (front) lock error
See SC750-31
 Front signature fan 1 overloaded, defective
 Slave Control Board defective
 Reconnect the connector.
 Replace the front signature fan 1.
 Replace the slave board.
 Replace the motor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-34
D
Perfect Binder: Signature fan 1 (rear) lock error
See SC750-31
 Rear signature fan 1 overloaded, defective
 Slave Control Board defective
 Reconnect the connector.
 Replace the rear signature fan 1.
 Replace the slave board.
 Replace the motor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
35
D
Perfect Binder: Glue supply fan (high) lock error
Glue supply (high) fan failed to generate a lock signal within 12 sec., and signal
could be detected even after a re-try.
 Glue supply fan (high) overloaded, defective