Ricoh PRO C7210X - Page 207

1.SC Codes
203
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
41
The left trimmings buffer HP sensor did not go OFF within 3 sec. after the
trimmings buffer moved away from the sensor.
 Trimmings buffer motor defective
Left trimmings buffer HP sensor defective, overload, connector broken defective,
Buffer full of trimmings
 Reconnect the connector.
 Replace the trimming buffer motor.
 Replace the left trimming buffer HP sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
42
D
Perfect Binder: Trimming buffer HP sensor late error
The left trimmings buffer HP sensor did not go OFF within 5 sec. after the
trimmings buffer moved toward the sensor.
Trimmings buffer motor defective, Left trimmings buffer HP sensor defective,
overload, connector broken defective, Buffer full of trimmings
 Reconnect the connector.
 Replace the trimming buffer motor.
 Replace the left trimming buffer HP sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
43
D
Perfect Binder: Right trimming buffer HP sensor lag error
The right trimmings buffer HP sensor did not go OFF within 3 sec. after the
trimmings buffer moved away from the sensor.
Trimmings buffer motor defective, Right trimmings buffer HP sensor defective,
overload, connector broken defective, Buffer full of trimmings
 Reconnect the connector.
 Replace the trimming buffer motor.
 Replace the right trimming buffer HP sensor.
 Replace the cutter control board.