Ricoh PRO C7210X - Page 206

1.SC Codes
202
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Replace the grip motor.
 Replace the grip HP sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
39
D
Perfect Binder: Grip end sensor lag error
 The grip end sensor did not go off after the grip unit released the signature
and moved the prescribed distance.
 The grip end sensor did not go off, even after the booklet had been released
after moving 86 mm.
 Grip motor defective, Grip end sensor defective, overload Sensor flag
defective, connector broken defective
 Reconnect the connector.
 Replace the grip motor.
 Replace the grip end sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
40
D
Perfect Binder: Grip end sensor late error
 The grip end sensor did not go on, even after the booklet had been moved
86 mm.
 The grip end sensor did not go on within 3.7 sec. after the book was gripped.
 Grip motor defective, Grip end sensor defective, overload, Sensor flag
defective, connector broken defective
 Reconnect the connector.
 Replace the grip motor.
 Replace the grip end sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
D
Perfect Binder: Left trimming buffer HP sensor lag error