Ricoh PRO C7210X - Page 209

1.SC Codes
205
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
connector broken defective, buffer full of trimmings
 Reconnect the connector.
 Replace the trimming buffer motor.
 Replace the thrust plate sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
47
D
Perfect Binder: Thrust plate retraction error
The paper press plate sensor did not go ON after the trimmings buffer moved to
the right for 3 sec. (blocked by jammed trimming scraps)
Trimmings buffer motor defective, Thrust plate sensor defective, overload,
connector broken defective, buffer full of trimmings.
 Reconnect the connector.
 Replace the trimming buffer motor.
 Replace the thrust plate sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
48
D
Perfect Binder: Book collection buffer HP sensor error
The book collection buffer HP sensor did not go OFF within the time prescribed
for release of the book in the book buffer.
Book buffer tray motor defective, Book collection buffer tray HP sensor defective,
overload, connector broken defective, blocked by
paper scraps
 Reconnect the connector.
 Replace the book buffer tray motor.
 Replace the book collection buffer tray HP sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.