Ricoh PRO C7210X - Page 210

1.SC Codes
206
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
49
D
Perfect Binder: Book collection buffer tray HP sensor late error
The book collection buffer HP sensor did not go off even after the book buffer tray
moved for 3 sec.
Book buffer tray motor defective, Book collection buffer tray HP sensor defective,
overload, connector broken defective, blocked by
paper scraps
 Reconnect the connector.
 Replace the book buffer tray motor.
 Replace the book collection buffer tray HP sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
50
D
Perfect Binder: Press HP sensor lag error
During press plate operation during trimming, the edge press plate HP sensor did
not OFF after it had time to move the prescribed distance.
Edge press plate motor defective, Press HP sensor defective, overload, connector
broken defective
 Reconnect the connector.
 Replace the edge press plate motor.
 Replace the press HP sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
51
D
Perfect Binder: Edge press plate late error
 Edge press plate sensor did not go ON within 15 sec. of edge press release.
 The edge press plage motor stopped when the edge press plate HP sensor
switched ON, but after it stopped the HP sensor went OFF.
 Edge press plate motor defective, Press HP sensor defective, overload,
disconnected
 Edge press plate motor defective, Press end sensor defective, overload
 Reconnect the connector.
 Replace the edge press plate motor.