Ricoh PRO C7210X - 8. Troubleshooting Paper Delivery Problems; Frequent Paper Misfeeds

1.SC Codes
207
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Replace the press HP sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
52
D
Perfect Binder: Press end sensor lag jam
After the press plate released the signature and moved the prescribed distance,
the press end sensor did not go OFF.
Edge press plate motor defective, Press end sensor defective, overload,
disconnected
 Reconnect the connector.
 Replace the edge press plate motor.
 Replace the press end sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
53
D
Perfect Binder: Press end sensor late jam
 The press end sensor did not go ON within 8 sec. after the press operation
started
 Operation stopped when the press end sensor went ON, but sensor went off
after the operation stopped.
Edge press plate motor defective, Press end sensor defective, overload,
disconnected, no data about book thickness received
 Reconnect the connector.
 Replace the edge press plate motor.
 Replace the press end sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-54
D
Perfect Binder: Press limit sensor error
Press limit sensor signaled ON.
Press limit sensor signaled ON.