Ricoh PRO C7210X - Page 212

1.SC Codes
208
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Reconnect the connector.
 Replace the press limit sensor.
 Replace the press HP sensor.
 Replace the cutter control board.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
55
D
Perfect Binder: Slide HP sensor lag error
When the slide was raised, the slide HP sensor did not go OFF after it moved
180 mm.
Slide motor defective, slide HP sensor defective, overload, disconnected, book
jam
 Reconnect the connector.
 Replace the slide motor.
 Replace the slide HP sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
56
D
Perfect Binder: Slide HP sensor late error
The slide HP sensor did not go ON after the slide was lowered and had enough
time to move 180 mm.
Slide motor defective, slide HP sensor defective, overload, disconnected, book
jam
 Reconnect the connector.
 Replace the slide motor.
 Replace the slide HP sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
57
D
Perfect Binder: Book rotation HP sensor (right) lag error
 The book rotation HP sensor did not go OFF after the book was rotated 60