Ricoh PRO C7210X - Page 220

1.SC Codes
216
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
Book door lock solenoid defective, Book door sensor defective, disconnect
 Reconnect the connector.
 Replace the book door lock solenoid.
 Replace the book door sensor.
 Replace the cutter control board.
 Replace the SOL harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
76
D
Perfect Binder: Glue heater error
The glue heater thermistor registered more that 200 degrees for more than 1
sec.
 Glue temperature thermistor defective
 Glue heater defective
 Slave board defective
 Reconnect the connector.
 Replace the gluing unit.
 Replace the slave board.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
77
D
Perfect Binder: Electrical short in the gluing unit
A temperature of less than 5 degrees was detected for 1 sec. or more than 10 sec.
after power on.) However, if the thermistor detected less than 100 degrees after
measuring temperature at start up, temperature is checked again after 50 sec.
 Glue temperature thermistor defective
 Glue heater defective
 Slave board defective
 Reconnect the connector.
 Replace the gluing unit.
 Replace the slave board.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
78
D
Perfect Binder: Glue heater startup error 1
Glue temperature thermistor did not detect a temperature of 140 degrees within
200 sec. after it detected a temperature over 50 degrees.
 Glue temperature thermistor defective
 Glue heater defective