Ricoh PRO C7210X - Page 219

1.SC Codes
215
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
disconnect, overload
 Reconnect the connector.
 Replace the book output belt motor.
 Replace the book output tray HP sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
73
D
Perfect Binder: Blade cradle HP sensor lag error
While the blade was retracting to the home position, the blade cradle sensor did
not go OFF after enough time had elapsed for the blade to move 12 mm.
Blade cradle motor defective, Blade cradle sensor defective, disconnect, overload
 Reconnect the connector.
 Replace the blade cradle motor.
 Replace the blade cradle HP sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
74
D
Perfect Binder: Blade cradle HP sensor late error
While the bladed was being lowered, the blade cradle HP sensor did not go ON
after enough time had elapsed for 21 mm of movement.
Blade cradle motor defective, the blade cradle HP sensor defective, disconnect,
overload, blade cradle or cutter physically jammed by obstacle
 Reconnect the connector.
 Replace the blade cradle motor.
 Replace the blade cradle HP sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Remove the blade and the edge press plate.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-75
D
Perfect Binder: Book door lock error
The book door sensor was detected OFF with the book door locked.