Ricoh PRO C7210X - Page 218

1.SC Codes
214
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-70
D
Perfect Binder: Book lift tray motor rotation error
No encoder lock input received within 50 ms during operation.
 Book lift tray motor defective,
 Book lift tray encoder sensor defective, disconnect
 Reconnect the connector.
 Replace the book lift tray motor.
 Replace the Book lift tray encoder sensor
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
71
D
Perfect Binder: Book output tray HP sensor lag error
 The book output tray HP sensor did not go OFF within 1 sec. after it went
ON.
 The book output tray HP sensor did not go OFF after enough time had
elapsed for the tray to move more than 10 mm.
Book output belt motor defective, Book output tray HP sensor defected,
disconnect, overload
 Reconnect the connector.
 Replace the book output belt motor.
 Replace the book output tray HP sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
72
D
Perfect Binder: Book output tray HP sensor late error
The book output tray HP sensor did not go ON within 3.5 sec. after it went OFF.
Book output belt motor defective, Book output tray HP sensor defected,