Ricoh PRO C7210X - Page 217

1.SC Codes
213
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Replace the blade.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-67
D
Perfect Binder: Trimmer limit sensor error
Trimmer limit sensor signaled ON.
Trimmer limit sensor defective
Blade sensors 1, 2 defective , disconnect
 Reconnect the connector.
 Replace the Trimmer limit sensor.
 Replace the blade sensors 1, 2.
 Replace the cutter control board.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
68
D
Perfect Binder: Book lift tray HP sensor lag error
 During tray lifting, the book tray lift sensor did not go off after 10 sec. had
elapsed.
 The book lift sensor did not go off after enough time had elapsed to move the
tray more than 10 mm.
Book lift tray motor defective, Book lift tray HP sensor defective, disconnect,
overload
 Reconnect the connector.
 Replace the book lift tray motor.
 Replace the book lift tray HP sensor.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
69
D
Perfect Binder: Book lift tray HP sensor late error
While the book lift tray was being lowered, the book lift tray HP sensor did not go
on after 1.5 sec. had elapsed.
Book lift tray motor defective, Book lift tray HP sensor defective, disconnect,
overload, Book jam, bundle drop
 Reconnect the connector.
 Replace the book lift tray motor.
 Replace the book lift tray HP sensor.