Ricoh PRO C7210X - Page 216

1.SC Codes
212
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Reconnect the connector.
 Replace the cutter motor.
 Replace the blade sensors 1, 2.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
65
D
Perfect Binder: Cut end late error
 During movement from front to rear during cutting, blade sensor 1 did not go
ON after enough time had elapsed for the blade to move 61 mm.
 During movement from front to rear during cutting, blade sensor 1 did not go
ON after 10 sec. had elapsed.
Cutter motor defective, Blade sensors 1 defective, disconnected, overload. Blade
is dull, not cutting efficiently.
 Reconnect the connector.
 Replace the cutter motor.
 Replace the blade sensors 1.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Replace the blade.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
66
D
Perfect Binder: Cut end lag error
 During movement from rear to front during cutting, blade sensor 1 did not go
OFF after enough time had elapsed for the blade to move 61 mm.
 During movement from rear to front during cutting, blade sensor 1 did not go
OFF after 10 sec. had elapsed.
Cutter motor defective, Blade sensors 1 defective, disconnected, overload. Blade
is dull, not cutting efficiently.
 Reconnect the connector.
 Replace the cutter motor.
 Replace the blade sensors 1.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.