Ricoh PRO C7210X - Page 215

1.SC Codes
211
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Replace the cutter motor.
 Replace the blade sensors 1, 2.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
62
D
Perfect Binder: Cutter rear HP sensor late error
When the blade was moved to the rear, it did not arrive at the home position after
122 mm of movement.
Cutter motor defective, Blade sensors 1, 2 defective, disconnected, overload
 Reconnect the connector.
 Replace the cutter motor.
 Replace the blade sensors 1, 2.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
63
D
Perfect Binder: Cutter rear HP sensor lag error
 When the blade moved from the rear HP sensor, it did not leave the rear HP
position after 20 mm of movement toward the front.
 When the blade moved to the front, the blade did not leave the home position
after the length of time elapsed for 10 mm of movement.
Cutter motor defective, Blade sensors 1, 2 defective, disconnected, overload
 Reconnect the connector.
 Replace the cutter motor.
 Replace the blade sensors 1, 2.
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
64
D
Perfect Binder: Cutter front HP sensor lag error
When the blade is moved to the front, the blade did not return to blade sensor 1
after enough time had elapsed for the blade to move 122 mm.
Cutter motor defective, Blade sensors 1, 2 defective , disconnect, overload