Ricoh PRO C7210X - Page 214

1.SC Codes
210
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
Book rotation motor 2 (left)defective, Book rotation HP sensor 2(left) defective,
overload, disconnected, book jam
 Reconnect the connector.
 Replace the book rotation motor 2 (left).
 Replace the book rotation HP sensor 2(left).
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
60
D
Perfect Binder: Book rotation HP sensor (left) late error
 The book rotation HP 2 (left) sensor did not go ON after the book was rotated
400 degrees.
 The book rotation HP 2 (left) sensor did not go ON after the book was rotated
360 degrees.
 Before the book is rotated before cutting, the book rotation HP sensor 2 (left)
did not go on, even after the book had been rotated twice the prescribed
distance.
Book rotation motor 2 (left)defective, book rotation HP 2 (left) sensor defective,
overload, disconnected, book jam
 Reconnect the connector.
 Replace the book rotation HP 2 (left) sensor.
 Replace the book rotation HP sensor 2 (left).
 Replace the cutter control board.
 Replace the motor harness.
 Replace the sensor harness.
 Clear the signature jam.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC750-
61
D
Perfect Binder: Cutter front HP sensor lag error
 At initialization, the blade did not leave the home position even after 20 mm of
movement.
 When the blade moved to the rear, the blade did not leave the home position
after the length of time elapsed tof 10 mm of movement.
Cutter motor defective, Blade sensors 1, 2 defective, disconnected, overload
 Reconnect the connector.