Ricoh PRO C7210X - Page 242

1.SC Codes
238
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Replace the spine close sensor (L).
 Replace the slave control board.
 Replace the motor harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC751-
56
D
Perfect Binder: Left spine fold plate open error
In the operation of the left spine fold plate, the left spine close sensor did not go
OFFN, even after the left spine fold plate motor was on for 500 ms.
When the spine fold plate moved from the open to closed position, the left spine
close sensor was already ON.
 Spine fold motor (L) connector loose, broken, defective
 Motor defective
 Spine close sensor (L) connector loose, broken, defective
 Reconnect the connector.
 Replace the spine fold motor (L).
 Replace the spine close sensor (L).
 Replace the slave control board.
 Replace the motor harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC751-
57
D
Perfect Binder: Spine fold HP sensor (L) error
The spine fold HP sensor (L) and spine fold close sensor (L) went ON at the
same time.
 Spine fold HP sensor (L) connector loose, broken, defective
 Sensor defective
 Spine close sensor (L) connector loose, broken, defective
 Sensor defective
 Reconnect the connector.
 Replace the spine fold HP sensor (L).
 Replace the spine close sensor (L).
 Replace the slave control board.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC751-
D
Perfect Binder: Spine fold HP sensor (R) error