Ricoh PRO C7210X - Page 249

1.SC Codes
245
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC751-
73
D
Perfect Binder: TE press lever HP sensor lag error
When the trailing edge press lever was released, the TE press lever HP sensor did
not go OFF, even though the TE press lever motor operated long enough to move
the lever through and arc of 20 degrees.
 TE press lever sensor defective
 TE press lever motor defective
 Reconnect the connector.
 Replace the TE press lever motor.
 Replace the TE press lever HP sensor.
 Replace the master control board.
 Replace the motor harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC751-
74
D
Perfect Binder: Jog fence front HP sensor late error
The front jog fence HP sensor did not go ON, even though the jog fence motor
operated long enough for 60 mm of feed.
 Jog fence front HP sensor defective
 Jog fence front motor defective
 Reconnect the connector.
 Replace the jog fence front motor.
 Replace the jog fence front HP sensor
 Replace the master control board.
 Replace the motor harness.
 Replace the sensor harness.
SC No.
Level
Error Name/Error Condition/Major Cause/Solution
SC751-
75
D
Perfect Binder: Jog fence front HP sensor lag jam
While small-size paper was being jogged, the jog fence front HP sensor did not go
OFF after the front jog fence motor operated long enough for 40 mm of feed.
 Jog fence front HP sensor defective
 Jog fence front motor defective
 Connector loose, broken, defective
 Reconnect the connector.