Envelopes
This section describes loading envelopes.
• Only envelopes (1) and (2) as shown below are supported.
Envelope types Supported/Not supported
Supported
*1
Supported
*1
Not supported
*1
Misfeeds might also occur when using envelopes (1) and (2) depending on the length and shape of the flaps.
To print on envelopes, load them into tray 1, 2, the Wide LCT, or the multi bypass tray, and be sure to
specify the appropriate paper type.
• For details about the types of envelope supported, consult your sales representative.
• Before loading envelopes, press down on them to release excess air and flatten out their edges. Make
sure that any curled envelopes are fully flattened before you load them.
• Humidity levels of over 50% can cause envelopes to come out creased or misprinted.
• Certain types of envelope might come out creased, dirtied, or misprinted. If the print image contains
areas of solid black, lines might appear where the envelopes overlapped.
• When printing on envelopes thicker than 127g/m
2
(34 lb. Bond), do not use Adjust Curl: Strong
or Adjust Curl: Strong for Adjust Paper Curl of Adjustment Settings for Operators.
Envelopes
99
To Next Page
Loading...
