Installing the Printer Driver in a Network Environment
11
1
Installing the printer driver
Use the following procedure to install the printer driver.
A On the [Printer Drivers and Utilities] dialog box, click [PCL 6 Printer Driver].
If you have already closed the [Printer Drivers and Utilities] dialog box, launch
“Setup.exe” from the CD-ROM root directory.
The software license agreement appears.
B After reading the agreement, click [I accept the agreement.], and then click
[Next >].
C In the dialog box that appears, select the [Search for network printers.] check
box, and then click [Next >].
If the search fails, the printer driver is installed via port LPT1.
Check the port settings and printer's IP address again, before reconfiguring
the settings.
D When the list of found printers appears, click this printer (whose IP ad-
dress you confirmed before the installation), and then click [Next >].
E Double-click the printer name to display the printer's settings, change the
settings as required, and then click [Continue].
F If a message appears informing you that the installation was successfully
completed, click [Finish].
Note
❒ When you click [Finish], the [Digital Signature Not Found] dialog box might
appear. To continue the installation, click [Yes].
❒ Auto Run might not work under certain operating system settings. If this
is the case, launch “Setup.exe” from the CD-ROM root directory.
❒ To stop the selected software installing, click [Cancel] before the installa-
tion is complete.
❒ A message appears if there is a newer version of the printer driver already
installed. If there is, you cannot install the printer driver using Auto Run.
If you still want to install the printer driver, use [Add Printer]. See p.22 “If a
Message Appears during Installation”.
Reference
For details about reconfiguring the printer settings when the search for
network printer fails, see p.12 “If the network printer search fails”.
For details about the network connection, see Hardware Guide.
To Next Page
Loading...
