Using Smart Organizing Monitor under the Macintosh Environment
4
Bypass Tray
v Paper Size
In the [Paper Size] list, select the size of paper loaded in the input tray.
When [Custom Paper Size] is selected, specify one of the sizes below.
v Paper Type
In the [Paper Type] list, select the paper type.
v Custom Paper Size
Enter the custom paper size when [Custom Paper Size] is selected.
•Unit
Select which units (mm or inch) to use for entering lengths in the [Horizontal]
and [Vertical] boxes.
• Horizontal/Vertical
Enter the custom paper size when [Custom Paper Size] is selected. In the
units selected earlier (mm or inch), enter the length of the paper's short and
long edges in the [Horizontal] and [Vertical] boxes respectively.
Note
r Available paper sizes vary depending on the paper tray. For details about set-
ting the paper size, see the printer operating instructions.
Tray Priority
Select the tray used for the priority paper source.
[Tray Priority] is the tray selected immediately after the printer is turned on, and
when Auto Select is chosen as the paper source for a job.
To Next Page
Loading...
