Printer Configuration
7
[System] Tab
Make system, access code, and language settings.
To configure a function, select the check box to the left of the function's name.
v Auto Continue
Select how the printer responds if it does not have a paper tray that contains
the paper size and type specified by a job.
•Off
The printer stops operation until the correct paper is loaded.
•On
After 10 seconds, the printer begins printing regardless of the size and type
of paper loaded in the tray.
v Copies
Specify a number of print copies (1 to 999).
v Sub Paper Size
Select whether or not to enable A4/Letter switching.
v 2 Sides Print
Prints on both sides of sheets.
•Off
Disables Duplex printing.
• Long Edge Bind
Prints output so that you can open it to the left when bound along the left
edge like a book.
• Short Edge Bind
Prints output so that you can open it to the top when bound along the top
like a calendar.
Note
r If you are using a printer that does not support automatic duplex printing,
perform normal single-sided printing, and then reset the sheet to print on
the other side.
v Blank Pages
Select whether or not to print on blank pages.
v Image Density Adjustment
Specify the print density (-3 to +3) in the box.
To Next Page
Loading...
