Using Smart Organizing Monitor under the Macintosh Environment
8
v Low Humidity Mode
If the printer is used in a room where humidity level is low, black lines of a
few millimeters thick may appear on printouts with 75 mm spaces in be-
tween. Selecting [On] for this setting may prevent these lines from appearing
(wait for about one day until this setting becomes effective). Note that when
this setting is enabled, the printer automatically performs self-maintenance in
every 10 minutes.
v Energy Saver Mode 1
When this function is enabled, less electricity is used.
v Energy Saver Mode 2
When this function is enabled, less electricity is used than under Energy Saver 1.
Note
r Even if [Energy Saver Mode 2] is enabled, the printer will not enter Energy
Saver Mode 2 for two hours if [Low Humidity Mode] is enabled.
v Energy Saver Mode 2 Timer
When [Energy Saver Mode 2] is enabled, you can specify a timeout period.
v Print Error Page
Prints an error report if an error occurs during print data processing.
v Device Comment
Enter a note about the printer, using up to 32 alphanumeric characters.
v [Restore Factory Defaults]
Resets all settings to their default values.
Access Code
Select whether or not to use the access code.
If you select [Use], the tabs you can see/set may vary depending on the access
code settings. If you select [Do not Use], the access code setting screen does not
appear before the [Printer Configuration] setting. [Do not Use] is set as the factory
default. Change it to [Use] if you want access code control.
• [Change Access Code...]
If you selected [Use] for [Access Code], click this button to change the access
code.
[Language]
Select the language you want to use.
To Next Page
Loading...
