1. Rear cover
Open to access the inside of the printer.
Open here to replace the fusing unit.
2. Power connector
Connect the power cord to the printer. Insert the other end into an electrical
outlet.
3. USB port A
Connect external devices such as a card authentication device, etc.
4. USB port B
Connect to the USB port of the USB device server. Remove the cover to use
this port.
5. Ethernet port
Use a network interface cable to connect the printer to a network.
6. Optional interface board slot
Insert an optional wireless LAN interface board, IEEE 1284 interface board,
or USB device server.
16
To Next Page
Loading...
