Message Cause Solution
"Rplcmnt Rqrd Soon:Drum Unit" You will need to replace the
drum unit soon.
Contact your sales or service
representative to obtain a new
unit.
"SD Card authenticatn.failed Error
recurs, call service."
Authentication from the SD
card failed.
Turn the printer off, and then
turn it on again. If the problem
persists, contact your sales or
service representative.
"Set the Drum Unit correctly." The drum unit may not be
installed correctly.
Turn the printer off, and then
install the drum unit again.
"Set the Maintenance Kit
correctly."
The fusing unit may have not
been installed correctly.
Turn the printer off, and then
install the fusing unit again.
If the message continues to
appear after the unit is
installed again, contact your
sales or service representative.
"Set the Toner Cartridge correctly." The print cartridge may have
not been installed correctly.
Turn the printer off, and install
the print cartridge again.
"Standard Tray is full. Remove the
paper."
The standard tray is full. Remove the paper.
"Supply order has failed." The automatic supply order
failed.
The message indicates the
printer tried to order the
supplies.
"This NetBIOS name is already in
use.(108/208)"
The NetBIOS name specified
for the printer is already used
by another device on the
network.
Contact your network
administrator.
"The same IPv4 Address already
exists.(102/202)"
The IPv4 address specified for
the printer is already used by
another device on the
network.
Contact your network
administrator.
"The selected job has already been
printed or deleted."
This message might appear if
you print or delete a job from
Web Image Monitor.
Press Exit on the message
screen.
3. Troubleshooting
64
To Next Page
Loading...
Need help?
General
Weight and Dimensions
