Message Cause Solution
"Par. I/F board has a problem." The printer's self-diagnostic
test failed due to a loopback
error.
Replace the IEEE 1284 board
that caused the error.
"Printer Font Error." There are problems with the
printer's font file.
Turn the printer off, and then
turn it on again.
If the problem persists, contact
your sales or service
representative.
"Problem with Hard Disk Please
call service."
The printer cannot detect the
hard disk.
Check that the hard disk
installed correctly. If the
problem persists, contact your
sales or service representative.
"Problem:Wireless card Please call
service."
The printer cannot detect a
wireless LAN interface board.
Check that the wireless LAN
interface board installed
correctly. If the problem
persists, contact your sales or
service representative.
"Replacmnt Requrd Maint. Kit" You need to replace the
maintenance kit.
For details, see "Replacing
Other Consumables",
Operating Instructions.
"Rep Rqrd: Drum U. (PrtSusp)"
"Printing was suspended. It will
resume after the Drum Unit is
replaced."
You need to replace the drum
unit.
For details, see "Replacing
Other Consumables",
Operating Instructions.
"Rep Rqrd: Drum U. (PrtSusp)"
"Replace Drum Unit."
You can still continue printing
with the existing drum unit, but
print quality is not guaranteed.
If printed pages come out
blurred or with streaks or
spots, replace the drum unit
with a new one.
For details, see "Replacing
Other Consumables",
Operating Instructions.
"Repl Requrd Soon Maint. Kit" You will need to replace the
maintenance kit soon.
Contact your sales or service
representative to obtain a new
unit.
When Messages Are Displayed
63
To Next Page
Loading...
