Specifying resolution
This section describes how to specify the scan resolution for the current job.
There are six resolution settings. The higher the resolution, the higher the quality but greater the file size.
1. Press the [Image Quality] key.
2.
Press the [ ][ ][ ][ ] keys to select the desired resolution, and then press the [OK] key.
• Press the [Escape] key to discard the current change and return to the initial screen.
• You can change the machine's default [Resolution] setting to always scan with a specific resolution
level.
• Temporary job settings are cleared in the following cases:
• When no input is received for the period of time specified in [System Auto Reset Timer] while
the initial screen is displayed.
• When the [Clear/Stop] key is pressed while the initial screen is displayed.
• When the machine's mode is changed.
• When the power is turned off.
• When the machine's default for the same setting is changed.
• For details about [Resolution], see p.259 "Scanner Settings".
• For details about [System Auto Reset Timer], see p.295 "Administrator Settings".
Scanning Using the Control Panel
193
To Next Page
Loading...
Need help?
General
