Message Causes Solutions
Out of Paper: X
The indicated tray has run out of
paper.
Load paper to the indicated tray. See p.99
"Loading Paper".
Out of Toner: X
Continue printing?
The machine has run out of the
indicated toner.
• Press [No] to cancel the job and
replace the indicated print cartridge.
See p.393 "Replacing Print
Cartridges".
• Press [Yes] to finish printing before
replacing the indicated print
cartridge.
Please Restart
Machine
The machine needs to be
restarted.
Turn off the power, and then turn it back
on.
Remove Paper:
Bypass Tray
The machine failed to proceed
with the print job, because tray
1 or tray 2 was specified as the
input tray but paper was set in
the bypass tray.
Remove paper from the bypass tray.
Replace Fusing Unit
The fusing unit is no longer
usable, and must be replaced.
Contact your sales or service
representative.
Replace IntTrans. Belt
The transfer belt is no longer
usable, and must be replaced.
Contact your sales or service
representative.
Replace:
Waste Toner Bottle
The waste toner bottle is full.
Replace the waste toner bottle with a new
one. See p.399 "Replacing the Waste
Toner Bottle".
RX Comm. Error
A reception error occurred, and
the fax could not be received
correctly.
If possible, contact the sender of the fax
and ask them to resend it.
Scan (NW)
Disconnected
A scanned file could not be sent
because the Ethernet cable was
not connected properly.
Reconnect the Ethernet cable properly,
and then try the operation again.
Scan (USB)
Disconnected
The USB cable was
disconnected while scanning
from a computer.
Reconnect the USB cable properly, and
then try the operation again.
Error and Status Messages on the Screen
389
To Next Page
Loading...
Need help?
General
