4. Enter the administrator password if required.
5. Click [OK].
• If the settings are not restored successfully, an error message appears. Try again to restore the file
completely.
Energy Saver Mode Tab
Energy Saver Mode
Item Description
Energy Saver Mode 1 Select [Active] to set the machine to enter Energy Saver mode 1 if the
machine has been idle for about 30 seconds.
It takes less time to recover from Energy Saver mode 1 than from power-off
state or Energy Saver mode 2, but power consumption is higher in Energy
Saver mode 1 than in Energy Saver mode 2.
Energy Saver Mode 2 Select [Active] to set the machine to enter Energy Saver mode 2 after the
period of time specified for [Waiting Time (1 min. - 240 min.)] is passed (1
to 240 minutes).
The machine consumes less power in Energy Saver mode 2 than in Energy
Saver mode 1, but it takes longer to recover from Energy Saver mode 2
than from Energy Saver mode 1.
• The printer recovers from Energy Saver mode when it receives a print job or when any key on the
machine is pressed.
PCL6 Mode
PCL6 Mode
Item Description
PCL6 Mode Set this to [Universal] when using the Universal Driver and to [SP C250/
C252] when using the normal driver.
5. Configuring the Machine Using Web Image Monitor
128
To Next Page
Loading...
