163
6
Settings
While playing back images in Q mode, you can set whether to use [Quick Zoom]
to magnify the playback image up to 10x when pressing the y button once.
1
Use the four-way controller (23) to select [Quick Zoom] in
the [W Setting] menu.
2
Use the four-way controller (
45
) to switch between
O
(On) or
P
(Off).
O (On) The Quick Zoom is available.
P (Off) The Quick Zoom is not available.
Set whether to display mode guides for the Capture Mode Palette and Playback
Mode Palette.
1
Use the four-way controller (23) to select [Guide Display] in
the [W Setting] menu.
2
Use the four-way controller (
45
) to switch between
O
(On) or
P
(Off).
O (On) The mode guides are displayed.
P (Off) The mode guides are not displayed.
Pixel Mapping is the function for mapping out and correcting defective pixels in
the image sensor. Run the Pixel Mapping function if image dots always seem to
be defective in the same place.
Auto Power Off does not function in the following situations:
• While taking pictures in j (Continuous Shooting) and c (Burst Shooting)
modes
• While recording a movie
• During a slideshow or movie playback
• While the camera is connected to a computer
• While the camera is communicating by wireless LAN of the FlashAir
Setting the Quick Zoom Function
Setting the Guide Display
Perform Pixel Mapping
To Next Page
Loading...
