Ricoh WG-60 - Resetting to Default Settings (Reset)

165
6
Settings
3 Use the four-way controller (45)
to choose the image for the start-
up screen.
Only images available for the start-up
screen are displayed. You can also choose
the pre-installed screen or guide display
start-up screen already stored in the
camera.
4 Press the 4 button.
The setting is saved.
You can reset the camera settings to their defaults. Refer to “Default Settings”
(p.182) for the reset settings.
1 Use the four-way controller (23) to select [Reset] in the
[W Setting] menu.
2 Press the four-way controller (5).
The [Reset] screen appears.
3 Use the four-way controller (2) to
select [Reset].
4 Press the 4 button.
The settings return to the defaults.
• Once the start-up screen has been set, it will not be deleted even if the
original image is deleted or the SD Memory Card or built-in memory is
formatted. However the image is deleted if you change the start-up screen
after deleting the recorded image or formatting the memory.
• The start-up screen is not displayed when set to [Off].
• The start-up screen is not displayed when you turn the camera on in
playback mode.
• Movies cannot be used for the start-up screen.
Resetting to Default Settings (Reset)
CancelCancelCancel
OKOKOK
101 00
-
00100 17100
-
0017
OKOKMENMENUMENU
OK
OK
Reset
Returns to default
settings
Reset
Cancel