ShiftMemTable
➥Appearance
ON Pressing “SHIFT” button will bring up the complete Memory Table
OFF Pressing “SHIFT” button will NOT show the memory table
In either setting, Pressing “SHIFT” will illuminate the button and the unit will await the
next button press in the desired button combo.
Note:
Pressing “MEM” + “SHIFT” will bring up the complete memory table,
regardless of this setting.
Show [Option]
➥Layout 1
Each of the Options below have an option of being ON or OFF.
Show INPUT
Show V-SET
Show I-SET
Show OVP
Show OCP
Show OPP
Show RL
Show t° -EXT
Show V-BATT
Show t° -BATT
Show TIME
Show CHARGE
When ON, the Option’s Value will be displayed when ‘Layout 1‘ is selected as the current
screen Layout.
Notes:
- A maximum of 6 ‘Show[Options]’ can be displayed at one time.
IF more ‘Show[Options]’ are selected:
The 6 ON options closest to the top of the list are shown.
- V-BATT, t° -BATT, and CHARGE are only shown if a battery is sensed on the
Charging (Green) Binding Post.
- ‘Show t° -EXT’ and ‘Show t° -BATT’ both reference the external temperature
probe.
- ‘Show t° -EXT’ - ALWAYS shows the temperature.
- ‘Show t° -BATT’ - Shows the temperature ONLY when a battery is
detected.
To Next Page
Loading...
