How to clean dirt, grease, or oil from RIDGID DP15501 Drill's chuck and spindle?
To address dirt, grease, or oil on the tapered inside surface of the chuck or on the spindle's tapered surface of your RIDGID Drill, clean the tapered surfaces of the chuck and spindle with a household detergent to remove all contaminants.
How to prevent wood splinters on underside with RIDGID DP15501 Drill?
Wood splintering on the underside when using the RIDGID Drill is likely due to the absence of “backup material” under the workpiece. Use “backup material” to prevent this.
Why does the RIDGID DP15501 Drill's quill return too slow or too fast?
If the quill on your RIDGID Drill returns too slowly or too fast, the spring likely has improper tension. Adjust the spring tension.
Why does the RIDGID DP15501 Drill bit bind in the workpiece?
If the drill bit binds in the workpiece when using your RIDGID Drill, it may be due to the workpiece pinching the drill bit or excessive feed pressure. Support or clamp the workpiece properly.
What to do if workpiece tears loose from hand using RIDGID DP15501?
If the workpiece is being torn loose from your hand while using the RIDGID Drill, it's likely not supported or clamped properly. Ensure you support or clamp the workpiece securely.
Why is the RIDGID Drill bit leading off and the hole not round?
If your RIDGID Drill bit leads off and the hole isn't round, it could be due to a hard grain in the wood, unequal cutting lip lengths, or incorrect angles. Resharpen the drill bit correctly or replace it. Another possibility is a bent drill bit, in which case you should replace it.
What to do if RIDGID DP15501's chuck rotates but lacks torque?
If the chuck on your RIDGID Drill rotates but doesn't provide enough torque, several things could be wrong. The drill bit might be bent, so use a straight one. The spindle bearings could be worn, requiring replacement. Make sure the drill bit is properly installed in the chuck. Also, verify that the chuck itself is correctly installed.
How to fix noisy operation of RIDGID DP15501 Drill?
Noisy operation in your RIDGID Drill can stem from several issues. The belt tension might be incorrect; adjust it. The spindle could be dry; lubricate it. Check if the spindle pulley is loose and tighten the retaining nut if needed. Also, ensure the motor pulley is secure by tightening the set screws in the pulleys.
Covers checking pulley alignment and adjusting belt speed.
Steps for correctly mounting the drill chuck onto the spindle.
Lists spindle speeds (RPM) achievable by changing belt positions.
Safety guidelines for personal protective equipment and planning work.
Advice on proper tool usage, maintenance, and workpiece support.
Safety tips for cutting large holes, including clamping and speed.
Warnings against using specific types of cutting tools like wire wheels or fly cutters.
Instructions on how to properly insert and secure a drill bit into the chuck.
How to tilt the table for bevel operations and return to 0°.
General| Model | DP15501 |
|---|---|
| Type | Drill Press |
| Motor Power | 1/2 HP |
| Chuck Size | 5/8 in. |
| Table Size | 12-1/2 in. x 10-1/2 in. |
| Weight | 152 lbs. |
| Voltage | 120V |
| Swing | 15 inches |
| Table Tilt | 45 degrees |
To Next Page
