16
ASSEMBLY
BLaDE
WRENCHES
MITER
gaugE
TO STORE THE TABLE SAW ACCESSORIES
See Figures 7 - 8.
The table saw has two convenient storage areas (one on
either side of the saw cabinet) specifically designed for the
saw’s accessories.
When not in use, store accessories securely.
RAISING AND LOWERING THE HANDLE
See Figure 9.
To raise the handle, pull the handle up.
NOTE: The handle will “click” as it locks in place.
To lower the handle, push the handle down into the handle
tube.
TO MOVE THE SAW
See Figure 10.
Holding the handle firmly, tilt the saw toward you until the
saw is balanced on the wheels.
Pull the saw to the desired location then either mount
to a firm supporting surface such as a workbench or leg
stand for immediate saw operation or store the saw in a
dry environment.
PuSH STICK
HaNDLE
Fig. 9
Fig. 10
Fig. 8
Fig. 7
To Next Page
