To Next PageTo Next PageWhat to do if my RIDGID Saw fails to start?
If your RIDGID Saw fails to start, first ensure the prongs on the cord plug are making good contact in the receptacle. Then, check the reset button on the Ground Fault Interrupter (GFI) receptacle, if applicable. Finally, inspect your power line for blown fuses or open circuit breakers.
General| Type | Table Saw |
|---|---|
| Corded/Cordless | Corded |
| Voltage | 120 V |
| Bevel Capacity | 0 - 45 degrees |
| Power Source | Corded |
| Blade Diameter | 10 inches |
| Motor Power | 15 Amp |
| Arbor Size | 5/8 inches |
Explains symbols and terms used in the manual to denote hazards and safety precautions for safe tool operation.
Provides critical safety guidelines for operating any power tool, covering work area, electrical, and personal safety.
Outlines essential safety precautions specific to table saws, including guarding, kickback, and cutting procedures.
Details the electrical requirements for the table saw, including voltage, amperage, and circuit protection.
Details how to adjust the riving knife height and align it with the blade for kickback prevention and safe cutting.
Ensures the rip fence is parallel to the blade for accurate ripping operations and covers its adjustment.
Provides solutions for common problems such as failure to start, fence issues, power loss, and finding repair services.
