29 - English
OPERATION
Fig. 42
RIGHT
WRONG
Fig. 41
CUTTING WARPED MATERIAL
See Figures 41 - 42.
When cutting warped material, always make sure it is posi-
tioned on the miter table with the convex side against the
fence as shown in figure 42.
If the warped material is positioned the wrong way as shown
in figure 41, it will pinch the blade near the completion of
the cut.
WARNING:
To avoid kickback and to avoid serious personal
injury, never position the concave edge of bowed
or warped material against the fence.
To Next Page
Loading...
