Riello RS 810/EV BLU - User Manual

76 pages

Save Page as PDF

To Next Page

Installation, use and maintenance instructions

20163082 (3) - 06/2021

Forced draught gas burner

Modulating operation

CODE MODEL TYPE

20160292 RS 810/EV BLU S032T2

Main Page

Table of Contents3
Declarations5
Information and General Warnings6
Information about the Instruction Manual6
Introduction6
General Dangers6
Other Symbols6
Delivery of the System and the Instruction Manual7
Guarantee and Responsibility7
Safety and Prevention8
Introduction8
Personnel Training8
Technical Description of the Burner9
Burner Designation9
Models Available9
Burner Categories - Countries of Destination10
Technical Data10
Electrical Data10
Burner Equipment11
Maximum Dimensions11
Firing Rates12
Test Boiler12
Burner Description13
Electrical Panel Description14
Control Box for the Air/Fuel Ratio (REC3715
Operation Sequence of the Burner17
4.13.1 List of Phases18
Operator Panel Operation18
4.14.1 Description of the Symbols on the Display18
4.14.2 Description of the Buttons19
Servomotor (SQM3320
Installation21
Notes on Safety for the Installation21
Handling21
Preliminary Checks21
Operating Position22
Removal of the Locking Screws from the Shutter22
Preparing the Boiler22
Boring the Boiler Plate22
Blast Tube Length22
Securing the Burner to the Boiler23
Access to Head Internal Part23
Probe-Electrode Position23
Combustion Head Adjustment24
Gas Feeding25
5.11.1 Gas Feeding Line25
5.11.2 Gas Train26
Gas Train Installation26
5.11.4 Gas Pressure26
Electrical Wiring27
Supply Cables and External Connections Passage28
Start-Up, Calibration and Operation of the Burner29
Notes on Safety for the First Start-Up29
Adjustments Prior to Ignition29
Burner Start-Up29
Air / Fuel Adjustment30
Air Adjustment for Maximum Output30
Air/Fuel Adjustment and Output Modulation System30
Burner Adjustment30
Output Upon Ignition30
Maximum Output30
Minimum Output30
Final Adjustment of the Pressure Switches31
Air Pressure Switch31
Pressure Switch Adjustment32
Maximum Gas Pressure Switch32
Minimum Gas Pressure Switch32
PVP Pressure Switch Kit32
Visualisation and Programming Mode33
Normal Mode33
Info Mode34
Service Mode35
Parameters Mode35
Parameter Modification Procedure36
Modify "Acceleration- Deceleration Train" Parameter38
Modify the Parameter for Continuous/Intermittent Operation (FS2/FS1)38
Start-Up Procedure39
Backup / Restore Procedure41
6.10.1 Backup41
6.10.2 Restore42
6.10.3 List of Parameters43
Operation47
Motor Lockout47
Ignition Failure47
Burner Flame Goes out During Operation47
Stopping of the Burner48
Final Checks (with Burner Operating)48
Maintenance49
Notes on Safety for the Maintenance49
Maintenance Programme49
Maintenance Frequency49
Safety Test - with Gas Feeding Closed49
Checking and Cleaning49
Measuring the Ionisation Current50
Safety Components50
Checking the Position of the Rpm Sensor50
Opening the Burner51
Closing the Burner51
Faults - Possible Causes - Solutions52
List of Error Codes52
A Appendix - Accessories61
B Appendix - Electrical Panel Layout63

Riello RS 810/EV BLU - User Manual

Table of Contents

Riello RS 810/EV BLU Specifications

Related product manuals

Brand	Riello
Model	RS 810/EV BLU
Category	Burner
Language	English