Riello RS 810/EV BLU - Securing the Burner to the Boiler; Access to Head Internal Part; Probe-Electrode Position

21
20163082
GB
Installation
5.7 Securing the burner to the boiler
 Fit the heat insulation supplied onto the blast tube
4)(Fig. 15).
 Fit the entire burner onto the boiler hole prepared previously
(Fig. 14), and fasten with the screws supplied.
5.8 Access to head internal part
 Remove the gas servomotor.
 Disconnect the socket 2)(Fig. 16) of the gas pressure switch.
 Remove the 4 fixing screws 3).
 Open the burner on the hinge as in Fig. 16.
 Unhook the probe cables and electrode 4).
 Turn the underneath part of the elbow 5) anticlockwise up to
release it from its housing.
 Undo the screw 6) with pressure test point.
 Remove the internal part of the head 7).
5.9 Probe-electrode position
Prepare a suitable lifting system using rings
3)(Fig. 15).
WARNING
The seal between burner and boiler must be
airtight.
Fig. 15
3
3
1
1
2
5
20162275
2
3
4
5
6
7
1
Fig. 16
20162276
WARNING
Check that the probe and the electrode are placed
as in Fig. 17, according to the dimensions indicat-
ed.
Fig. 17
ProbeElectrode
8
18.5
20162129