EasyManuals Logo

Rigol DG1012 Programming Guide

Rigol DG1012
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #68 background imageLoading...
Page #68 background image
RIGOL DG1000 Command System
Programming Guide for DG1000
2-56
MEMory
The generator has 10 storage locations (STATE1 to STATE10) in non-volatile memory
to store instrument states. The locations are numbered from 1 to 10. Location 0 is
volatile memory and the generator automatically uses location “0” to hold the state of
the instrument at power-down. MEMory commands can be used to read the location
names, delete the stored instrument states, automatically recall instrument state and
query the available storage locations. You can also assign a user-defined name to
each of the locations (1 to 10) from the front panel.
DG1000 supports following MEMory commands:
1. MEMory:STATe:NAME
2. MEMory:STATe:NAME?
3. MEMory:STATe:DELete
4. MEMory:STATe:RECall:AUTO
5. MEMory:STATe:RECall:AUTO?
6. MEMory:STATe:VALid?
7. MEMory:NSTates?

Other manuals for Rigol DG1012

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Rigol DG1012 and is the answer not in the manual?

Rigol DG1012 Specifications

General IconGeneral
Output Channels2
Sample Rate100 MSa/s
Vertical Resolution14 bits
Waveform TypesSine, Square, Ramp, Pulse, Noise, DC
Output Impedance50 Ω
Modulation TypesAM, FM, PM
Power Supply100 - 240 V AC, 50/60 Hz

Related product manuals